Skip to main content

How Much Does Welding Cost?

It's the first question almost everyone asks, and the honest answer is "it depends" — but that's not helpful when you just need a ballpark. Below are realistic 2026 price ranges for the most common welding and fabrication jobs, what drives the cost up or down, and how to get an accurate quote without guesswork. Prices reflect typical shop rates in the Florence and greater Pee Dee region.

Part of our Custom Metal Fabrication service.

Welder hourly rates

Most welding shops charge between $65 and $125 per hour. Mild steel repairs sit at the lower end, while aluminum and stainless steel work command more because they take more skill, prep, and specialized equipment. Many shops also set a minimum charge — often equal to about an hour of labor — so a five-minute weld still has a floor price. Ask up front whether you're being billed hourly or by a flat rate for the specific job.

Common repair price ranges

Exhaust / muffler weld: $50–$150 for a clean re-weld; more if a section of pipe must be fabricated.

Trailer frame or hitch repair: $100–$400 depending on the extent of cracking and metal thickness.

Gate, railing, or fence repair: $100–$350, with custom fabrication priced separately.

Aluminum boat or marine repair: $125–$500+, driven by access, thickness, and weld length.

Custom fabrication: quoted per project — material plus labor at the hourly rate.

These are typical ranges, not fixed quotes. The true cost depends on the metal, the condition of the part, and how much prep and fabrication the job requires.

What drives the price up or down

Four things move a welding price more than anything else: the type of metal (aluminum and stainless cost more than mild steel), the condition of the part (rusted, dirty, or previously botched welds take longer to prep), the complexity (a single tack weld versus structural fabrication), and where the work happens (in-shop versus on-site). Clean, accessible steel is cheap to weld; corroded aluminum on a hard-to-reach spot is not.

Shop vs. mobile welding

Bringing the item to the shop is almost always the cheapest option for anything you can transport. Mobile welding adds a service-call or travel fee, but it's well worth it — and often the only option — when the item is too large, too heavy, or fixed in place, like gates, structural steel, or heavy equipment. If you can load it in a truck bed, the shop is cheaper; if you can't, mobile service saves you far more than the fee.

Ready to move forward? See our Custom Metal Fabrication service

Request a quote

Written by the Lawhon Welding & Fabrication team.

Lawhon Welding & Fabrication

GET YOUR QUOTE TODAY

Get a Quote